SMART Board Board 600i6, Configuration And User'S Manual

Page: 66 / 117

C H A P T E R 6
Troubleshooting your interactive whiteboard system
53
Resolving ECP issues
If the ECP isn’t receiving power, complete the following tasks:
l
Confirm that the ECP cable harness’s 11-pin connector is properly connected to the ECP.
l
Confirm that the ECP cable harness’s 7-pin min-DIN connector is properly connected to the
ECP connector on the projector.
Accessing the service menu
C A U T I O N
l
To prevent tampering or unintentional changes, only system administrators should access
the service menu. Do not share the service menu access code with casual users of your
interactive whiteboard system.
l
Do not adjust any settings in the service menu other than those listed in this guide.
Changing other settings can damage or affect the operation of your projector and may
invalidate your warranty.
Retrieving your password
If you forget the projector’s password, you can retrieve it by accessing the projector service menu
directly from the projector or from the password settings menu on your projector’s webpage (see
Password settings on page 62).
To retrieve your password from the service menu
1. Using the remote control, press the following buttons quickly to access the service menu:
Down , Up , Up , Left , Up .
2. Scroll to Password Get and then press Enter on the remote control.
The password appears on the screen.
3. Write down the password.
4. Scroll to Exit and then press Enter on the remote control to exit the projector service menu.