SMART Board 8070i, User Manual, Page: 39 / 96

I
I M P O R T A N T
The remote control system does not function when strong light strikes the remote control
sensor or when there is an object between the remote control and its sensor.
Placing or replacing batteries in the remote control
Your remote control requires two 1.5V AA batteries.
W
W A R N I N G
To reduce the risk associated with leaking batteries:
l
use only AA type batteries
l
do not mix used and new batteries
l
orient the battery’s plus (+) and minus (-) terminals according to the markings found on
the remote control
l
do not leave the batteries in the remote control for an extended period
l
do not heat, disassemble, short or recharge the batteries, or expose them to fire or high
temperature
l
avoid eye and skin contact if batteries have leaked
l
dispose of exhausted batteries and product components in accordance with applicable
regulations
g
To place batteries in the remote control
1. Press the tab on the underside of the remote control, and then slide it to open the cover.
2. Remove the batteries if they are present.
3. Insert two 1.5V AA batteries in the remote control. Ensure the + and - markings on the
batteries align with the markings in the remote control.
4. Replace the cover.
C H A P T E R 5
Using your interactive display
31