SMART Board 480i6, Configuration And User'S Manual

Page: 62 / 106

A P P E N D I X A
Remotely managing your system through a network interface
54 smarttech.com/kb/170584
Submenu setting Description
HDMI Assigns an alternative name to your HDMI input, which appears
when you select the HDMI input.
Emergency Alert Turns the on-screen alert broadcast message on or off. When
enabled, this message displays over the current projected image.
Alarm Message / Alert
Message
Displays an on-screen emergency notification message (maximum
60 characters).
Control panel II
USB Control settings
This menu contains settings that are applicable only to SMART Board interactive whiteboard
systems with ECPs.
Submenu setting Description
USB1 Source This setting is applicable only to SMART Board interactive
whiteboard systems with ECPs.
USB2 Source This setting is applicable only to SMART Board interactive
whiteboard systems with ECPs.
Network settings
This menu allows you to use or not use Dynamic Host Control Protocol (DHCP) and to set the
network-related addresses and names when DHCP is not used.
Submenu setting Description
DHCP Determines if the projector’s IP address and other network settings
are dynamically assigned by a DHCP server or manually set.
l
On allows the network’s DHCP server to assign a dynamic IP
address to the projector.
l
Off allows you to manually set the projector’s IP address and
other network settings.
IP Address Displays or allows you to set the projector’s IP address in values
between 0.0.0.0 and 255.255.255.255.
Subnet Mask Displays or allows you to set the projector’s subnet mask number in
values between 0.0.0.0 and 255.255.255.255.
Gateway Displays or allows you to set the projector’s default network gateway
in values between 0.0.0.0 and 255.255.255.255.