6 SETUP AND INSTALLATION
Table 6.1 –
Continued from previous page
Transport Case Image
Dimension and Weight
Content
Height x Width x Depth:
(9) Environmental Module
4cm x 16cm x 15cm
(optional)
Weight:
0.3kg
Height x Width x Depth:
(10) Breakout-Box
15cm x 45cm x 40cm
(optional)
Weight:
(11) BOB Cable
4.62kg
(optional)
In case you have bought an in-vacuum
system, there should be additional components like
fi
ber
feed-throughs and
fi
ber patch cords. A complete list of all
PICO
SCALE
components and accessory
can be found on the SmarAct web page.
6.2 Unpack the system
1. Unpack the
PICO
SCALE
system in an area that is clean and dry. Be very careful, especially
with fragile optical and vacuum components.
2. Check each shipping container to be sure you have removed all transport cases and addi-
tional items. Do not discard the reusable shipping containers until it is certain that all items
have been removed.
I
t is recommended to keep the shipping containers in case you must
return any equipment to SmarAct.
3. Open each transport case and unpack the system components.
4. You are now ready to set up the system in the desired location.
6.3 Cabling
For the
fi
rst time installation, the
PICO
SCALE
has to be connected via USB to the measurement
PC. Note, that the PC is not part of the system and has to be supplied by the customer separately.
Connect the included USB cable to the USB slave interface at the back side of the
PICO
SCALE
Controller (
fi
gure 5.2, No. 6) and to the desired USB port at the user PC. After that, connect the
power supply cable to the power connector at the back side of the controller (
fi
gure 5.2, No. 2).
43
PicoScale User Manual
