RP-2023
ROOM CONTROL PANEL
Doc: 00-11-01, V1.2, 20170209
Page 1 / 2
Copyright © Smallart
®
www.smallart.com.tr
RP-2023 Room Panel User Manual
Sensing element: NTC
Accuracy :
± 1
℃
Set-point range: 5
℃～
35
℃
Display range: 0
～
50
℃
Operation environment: 0
～
45
℃
Operating Humidity: 5
～
90%RH (non-
condensing)
Power supply: 12VDC
Rated Power:
1W
Dimensions: 86 × 86 × 13 mm ( W × H × D )
Hole pitch: 60 mm ( Standard )
Protection Class: IP30
OPERATION
On/Off: Press
“ ” to turn on, press “ ” again to turn off.
Setting temperature: Press
“
” to reduce set-point, press “
” to raise set-point, and 1
℃
changed once.
Mode Selection
: Press “ ” to change system working in cooling “ ”, heating “ ”, ventilation “ ” or auto
“
”
mode.
Fan Speed Selection: P
ress “ ” to change fan speed among “ (Hi)”, “ (Med)”, “ (Low)” or “ (Auto)”.
KEY LOCKING FUNCTION SETTING:
Turn on the thermostat, Press
“ ” and “
” for 10 seconds to enable or disable key locking function.
ROOM TEMPERATURE CALIBRATING:
Turn on the thermostat, press
“ ” and “ ” for 10seconds, LCD will display current temperature and
calibration temperature.
Press
“
” to reduce calibration temperature or press “
” to increase.
FAN/AUTO FAN SELECTION:
Press
“ ” for 10 seconds to enable fan or auto fan mode. In auto fan mode,
“
AUTO
”
will be displayed in
clock area.
ADDRESS SETTING
Turn off the thermostat, simultaneously press
“ ” and “
” for 5 seconds till to display “XX” and
“31”
on
clock region
,
press
“
” and “
” to number the remote master address (Available range = 0~99). Press
“ ”
to
switch to the RP-2023 address,
“32” will display on the clock region, press “
” and “
” to number them (Available
range from 1~32).
MOUNTING INSTRUCTION
Use the flush mounting box for each application.
SINGLE DEVICE
Open the mounting hole to its proper place using a
68 mm holesaw
