Sloan EBV-200-A SMOOTH Installation Instructions Download Page 1

Page: 1 / 4

EBV-200-A SMOOTH FLUSHOMETER RETROFIT KIT INSTALLATION INSTRUCTIONS

Code No. 0816556

Rev. 0b (07/07)

INSTALLATION INSTRUCTIONS

(SIDE-MOUNT-OPERATOR-OVER-THE-HANDLE)

FLUSHOMETER RETROFIT KIT

Pull and swing Mounting Clamp to the
open position.

NOTE: Water does not need to be shut off.

Slide the unit over the existing handle up
to the flushometer body.

Swing the Mounting Clamp around the
flushometer body and press the clamp
end into the unit until it clicks into place.

Tighten unit by pushing in on the
spring loaded Mounting Screw and
turning clockwise with a 1/8” hex
wrench.

Do Not overtighten.

Remove Adhesive Label from sensor
window.

NOTE:

Red LED light will flash and

product will cycle. Unit is now ready
for use.

Summary of Contents for EBV-200-A SMOOTH

Page 1: ...eed to be shut off 2 Slide the unit over the existing handle up to the flushometer body 3 Swing the Mounting Clamp around the flushometer body and press the clamp end into the unit until it clicks int...

Page 2: ...t waits for the user to step away before initiating a flush cycle LOW BATTERY INDICATOR A manual flush cycle may be initiated by fully pressing and releasing the Override Handle INITIATING A MANUAL FL...

Page 3: ...ries Mode A The SMOOTH unit may be reset to normal range by fully pressing and holding in the Override Handle until the Red LED light in the Sensor Window illuminates Then immediately release the Over...

Page 4: ...ly to persons or organizations who purc hase Sloan Valve Company s products directly from Sloan Valve Company for purpose of resale This warranty does not cover the life of the batteries THERE ARE NO...