POWER CORD
The power cord extension is then installed into the mount bracket with
2x
M3 x 8mm FLAT HEAD
screws. Once the power cord has the bracket
attached and power cable is routed through the grommet. It may be
attached to the case frame via
2x
M3 x 5mm FLAT HEAD
screws at any
of the viable mount locations. The bracket can be positioned to where it
least obstructs the motherboard or GPU ports. Make sure to point the
open end of the inlet towards the rear of the case!
The SV540 includes an internal power cord extension, protective grommet, and
mount bracket for routing the power supply inlet into the"cable cubby" of the case
frame. Clip the
Cable Grommet
onto the power cord before you install it into the
case, then run the cord through the cutout located above the PCIe card tab cutout,
and finally slide the grommet into position as shown below.
