Middle slide chute (V)
1 - 1. The Top slide chute (J) and the Middle slide chute (V) have tongue-and-groove joint
on the edge for the connection.
1 - 2. Turn the Top slide chute (J) and the Middle slide chute (V) to the back side.
(Figure 1)
1 - 3. Connect the top slide chute (J) and Middle slide chute (V) by embedding
tongue-and-groove joint firmly. (Figure 2)
(Figure 1)
(Figure 2)
(J)
(V)
NOTE:
The easiest way to install the two chute pieces is to lay both of them flat on
a table, with the backside facing up -- towards you. Connect the pieces together as
closely as you can. With your heel of your hand, press down on the connection
point until there is no gap. Doing this on a table is best, as you can remain
standing and give more pressure to the heel of your hand, as needed.
Page 4 of 11
1 - 4. Turn the Top slide chute (J) and the Middle slide chute (V) onto the logo side.
Use a rubber mallet to strike on the edge of connection.
NOTE: Please ensure that the slide pieces connect without any gaps.
1 - 5. Fasten the Top slide chute (J) and the Middle slide chute (V)
together by using the steel plate (X) x 1 and bolt (Q) x 2. (Figure 3)
FLAT TABLE
Summary of Contents for SW-04
Page 11: ...Page 11 of 11 ...
