SLE SLE4000 Model B, Service Manual, Page: 38 / 328

Page 38 (Model C)
8.8 M0901 Batteries
1. Remove the L0275
Computer/Display
Control assembly as
described in section
8.5.
2. Remove the
Control/Monitor board
as described in
section 8.6.
3. Disconnect all the
battery terminal leads.
4. Remove the four
retaining screws for
the first two battery blocks.
5. Remove the two batteries.
6. Remove the two fixing screws and washers
(A) , securing the fixing bracket (B) for the third
battery.
7. Slide the battery forward and lift clear.
8. Remove the two fixing screws to
release the bracket from the battery
block.
9. Assembly is reversal of removal.
Setup: No setup is required for this
device. The ventilator should be left
connected and turned on for a minimum
of 24 hours to fully charge the batteries.
 A

A
B
