IDP 700 Terminal Series - Hardware Guide
© SkyWave Proprietary 29 T206, Version 01
Figure 25 LED Location
4.5.2
Drill Mounting Holes for the Transceiver Unit (optional)
Note:
These steps are only required if your Solution Provider did not provide you
with a mounting bracket.
1.
Use the terminal to mark the location of the four mounting holes.
Figure 26 Mounting Holes
2.
Drill the four mounting holes using the drill with the 5.5 mm bit.
3.
Use the screwdriver and socket set to lock the terminal in place with the mounting
hardware.
CAUTION
Torque hardware to 2.15 N-m.
Do not over tighten.
4.6
Connect the Cables
CAUTION
Cable management and connector strain relief must be
incorporated in the installation. SkyWave highly recommends
securing the cable at regular intervals along its length as part
of the installation to prevent cable wear and eliminate strain
on the connector. Damage to the connector interface or cable
may otherwise result and lead to hardware failure.
4.6.1
Connect the Cables without a Cable Shroud
1.
Connect the satellite antenna (Figure 27) to the curry yellow FAKRA connector on
the terminal by pushing until you hear a click.
Two
mounting
holes on
each side of
the unit
Application
Card LED
GPRS
LED
Summary of Contents for IDP 700 Series
Page 70: ...www SkyWave com ...
