SkyTrac Systems Ltd.
Document Rev. 01.020
DOC0334
Page 23 of 49
Restricted Proprietary and Confidential Information
3.9 Connecting the Battery to the ISAT-200
The ISAT-200 is shipped with the battery mounted but not connected to the power board. This is to
prevent the battery from being depleted before the ISAT-200 is installed in an aircraft. To connect
your battery, please follow the instructions below:
1. Remove the eight screws on the side panel of the ISAT-200, and then remove the battery
cover panel as shown in Figure 2 below.
2. Connect the battery to the power board. Insert the 4-pin battery cable connector into the
battery connector (J2 for 101-200-03, J1 for 101-200-01), and push until it is securely in
place.
3. Reinstall the battery cover panel with the eight screws that were previously removed.
Figure 2
— ISAT-200 Side Panel Detail
For battery replacement and maintenance, refer to section
3.10 Installing ISAT-200 into ITRAY-200
1. Slide the ISAT-200 into the tray from the front until it is snug.
2. Fasten the front hold down tab using the provided socket head cap screws, lock washers and
washers. Tighten the bolts until the split ring is compressed, and then tighten at least
another ¼ turn.
CAUTION:
Use only an approved STS battery. Using an unapproved battery will damage your
ISAT-200 and void the warranty.
The document reference is online, please check the correspondence between the online documentation and the printed version.
