REV. 10/29/03
Page 1 of 6
CON 1001 TH
(SKY CON TH)
INSTALLATION AND OPERATING INSTRUCTIONS
MULIT-FUNCTION WIRELESS REMOTE CONTROL SYSTEM
FOR OPERATING A LATCHING SOLENOID VALVE, MANUALLY OR WITH A THERMOSTAT FUCTION
INTRODUCTION
This remote control system was developed to provide a safe, reliable, and user-friendly remote control system for gas heating appliances. The
system is operated manually from the transmitter. The system operates on radio frequencies (RF) within a 20' range using non-directional
signals. The system operates on one of 1,048,576 security codes that are programmed into the transmitter at the factory; the remote
receiver's code must be matched to that of the transmitter prior to initial use.
Review THERMO SAFETY SECTION under RECEIVER section. This high temperature safety feature shuts down
the appliance when a potentially unsafe condition exists.
TRANSMITTER
This remote control SYSTEM offers the user a battery-operated remote control to power
a latching solenoids such as those used with gas valves used in some heater rated gas
logs, gas fireplaces and other gas heating appliances.
The solenoid circuit uses the battery power from the receiver to operate a solenoid. The
circuit has reversing polarity software which reverses the positive (+) and negative (-)
output of the receiver's battery power to drive a latching solenoid ON/OFF. The
SYSTEM is controlled by the remote transmitter.
The transmitter operates on a (2) 1.5V AAA batteries.
It is recommended that ALKALINE batteries always be used for longer battery life and
maximum operational performance.
Before using the transmitter, install the (2) AAA transmitter batteries into the battery
compartment. (Use caution that batteries are installed in the proper direction)
KEY SETINGS
•
ON - Operates unit to on position, Manually operated solenoid ON.
•
OFF - Operates unit to off position, Manually operated solenoid OFF.
•
MODE - Changes unit from manual mode to thermo mode.
•
SET - Sets temperature in thermo mode.
1. DISPLAY
Indicates CURRENT room temperature
.
2.
0
F
OR
0
C
Indicates degrees Fahrenheit or Celsius.
3. FLAME
Indicates burner/valve in operation.
4. ROOM
Indicates remote is in THERMO operation.
5. TEMP
Appears during manual operation.
6. SET
Appears during time the of setting the desired temperature in
the thermo operation.
ROOM
LCD - Liquid Crystal Display
TEMP
1
2
3
SET
4
5
6
ON
MODE
OFF
SET
1
2
3
4
ON
MODE
OFF
BUTTON
WALL CLIP
SLOT
BATTERY
COMPARTMENT
FRONT
BACK
OFF
SET
ON
BUTTON
MODE
BUTTON
SET
BUTTON
IF YOU CANNOT READ OR UNDERSTAND THESE INSTALLATION INSTRUCTIONS DO NOT
ATTEMPT TO INSTALL OR OPERATE
www.FireplaceRemoteControls.com
1.877.374.4404
