TI Plus 2 Manual
Your device defaults to centigrade upon power up. To change your readout to Fahrenheit follow these
steps:
1.
Press and release the MODE button one time to get the bottom readout into calendar mode.
2.
Hold the MODE button for 2 seconds to get into the SET mode. The year will blink.
3.
Press and release the SET button 4 times until the
“
C
”
for Centigrade blinks.
4.
Press the up or down arrow to change from
“
C
”
to
“
F
”
for Fahrenheit.
5.
Press and release the Mode button to complete.
INSTALLING BATTERIES
Two CR2032 Lithium batteries should be used in this unit. Use a coin to open the lid of the battery
compartment on the back of the unit. Turn to the direction of the Unlock icon to open. Please make
sure the positive post (+) of the two batteries face upward when the batteries are placed inside. Put the
lid back on the compartment and turn to the direction of the Lock Icon to close. Please make sure the
rubber ring is in position and the lid is closed firmly to make sure the unit is water resistant.
Note: If the Low Battery Power Icon is displayed, it is highly recommended to have the batteries
replaced as soon as possible.
TIMING FUNCTION
There are 4 modes in the Timing Function: Clock, Date, Alarm and Count-Down Timer. Pressing Mode
Button will switch from one mode to another sequentially.
TO SET THE CLOCK
1.
Get to the Clock Mode by pressing the MODE Button.
2.
Hold the MODE Button for 2 seconds.
3.
Press the UP or DOWN Button to adjust the digit.
4.
Press SET Button to advance to another digit and repeat procedure (3). You will be able to set
the Hour, Minute and 12/24 Hour format here.
5.
When you are done with the setting, press the MODE Button to complete.
TO SET THE DATE / TEMPERATURE UNIT / DATE FORMAT
1.
Get to the Date Mode by pressing MODE Button.
2.
Hold the MODE Button for 2 seconds.
3.
Press the UP or DOWN Button to adjust the digit.
4.
Press the Set Button to advance to another digit and repeat procedure (3).
5.
When you are done with the setting, press the MODE Button to complete.
TO SET THE ALARM
1.
Get to the Alarm Mode by pressing MODE Button.
