1. Safety Information
1. Safety Information
2. Package Contents
2. Package Contents
3. Insert Battery in the Motion Sensor
3. Insert Battery in the Motion Sensor
5. Program the PS2-MT with SkylinkNet Internet Hub
5. Program the PS2-MT with SkylinkNet Internet Hub
4. Program the PS2-MT with M series Main Console
4. Program the PS2-MT with M series Main Console
User Manual
Motion Sensor
PS2-MT
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired
operation.
WARNING:
Changes or modifications to this unit not expressly approved
by the party responsible for compliance could void the user’s
authority to operate the equipment.
CE - DECLARATION OF CONFORMITY:
This equipment complies with the requirements relating to
electromagnetic compatibility, EN 301489-1, EN301489-3,
EN300220-1, EN300220-2 and EN60950-1. This equipment
conforms to the essential requirement of the 1999/5/EC
R&TTE Directive.
Motion Sensor
PS2-MT
Ball Head
Joint
Mounting
Accessories
1. Unscrew the compartment
door and slide down to
open.
2. Insert battery inside the
compartment.
3. Slide back and screw
compartment door to
close.
Requires 2 x AAA
alkaline batteries.
NOT INCLUDED.
Leave compartment
door open until all
programming sections
are completed.
3. Open the PS2-MT
battery door and
press the ‘SET’
button.
4. Once the PS2-MT is
programmed, the Main
Console will beep once
and the corresponding
zone LED will be off.
Maximum 4 sensors in one zone. Programming a fifth
sensor will displace the first sensor.
Maximum 4 sensors in one zone. Programming a fifth
sensor will displace the first sensor.
1. Press the learn
button on the back
of the M-Series
Main Console for 3
seconds until the
Zone 1 light is
flashing.
2. Zone 1 is selected.
Press the learn button
to select the zone you
want to program the
sensor.
‘SET’ Button
Learn
Button
Zone
LED
Must use the SkylinkNet App to program the PS2-MT with the SkylinkNet Internet Hub.
1. Go to “More” and
tap on “System
2. Tap on “Setup
Wizard.”
4. Tap on “Sensors.”
3. Tap on “Add Device.”
5. Tap on “Motion
Sensor.”
6. Name your Sensor,
location and tap
“Continue.”
7. Tap on “Learn Now” and follow the
video to activate the sensor.
