Telescopic Boom Series
Models SJ61T & SJ66T
194312
December 2007
Page 211
Section 5 - Procedures
Service and Maintenance
Hydraulic Tank
Maintaining the hydraulic components and hydraulic oil
at the proper level are essential to good performance
and service life of the aerial platform.
5.7-1 Change Hydraulic Tank Filter
1. Ensure aerial platform is on a firm level
surface, is in stowed position and engine is
off.
2 Place suitable container under the hydraulic
tank filter.
3. Remove oil filter and catch any escaping oil.
4. Clean inside the filter head.
5. Apply a thin layer of clean hydraulic oil to
the new oil filter gasket.
6. Install filter and tighten firmly.
7. Clean up any oil that may have spilled during
this procedure.
8. Start engine from base control console.
9. Check for leakage.
NOTE
Refer to your national/local regulations
on how to dispose of used filter and oil.
5.7-2 Change Hydraulic Oil
1. Ensure aerial platform is on a firm level
surface and is in stowed position.
2. Allow hydraulic oil to warm up.
3. Turn main power disconnect switch to off
position.
4. Place suitable container under the hydraulic
tank.
5. Remove oil drain plug and allow all hydraulic
oil to drain into container.
6. Install oil drain plug with new seal ring and
tighten firmly.
7. Refill hydraulic tank with new oil as per
specifications. (Refer to
Section 2
of this
manual)
8. Check for leakage.
9. Clean up any oil that may have spilled during
this procedure.
10. Check hydraulic oil level. (The hydraulic oil
level should be at or slightly above the top
mark on the sight gauge)
NOTE
Refer to your national/local regulations
on how to dispose of used filter and oil.
NOTE
Samples of hydraulic oil should be drawn
from the reservoir and tested annually.
These samples should be taken when the
oil is warmed through normal operation
of the system. The sample should be
analyzed by a qualified lubrication
specialist to determine if it is suitable for
continued use. Oil change intervals will
depend on the care used in keeping the
oil clean, and the operating conditions.
Dirt and/or moisture contamination will
dictate that the oil should be changed
more often. Under normal use and
operating conditions, the hydraulic oil
should be changed every two years.
Refer to
Table 1.2
of this manual.
Summary of Contents for SJ61T
