Skyjack 6826El, Operating Manual

Page: 18 / 47

April 2006
SKYJACK, Page 18 SJIII Series E - CONVENTIONALS
Section 2 - Operation Component Identification
2.2-8 Maintenance Support
Figure 2-6. Maintenance Support
1. Maintenance Support - The maintenance
support is a safety mechanism designed to
support the scissor assembly. When properly
positioned it can support the scissor assembly
and empty platform. The maintenance support
MUST be used when inspection and/or
maintenance is to be performed within the lifting
mechanism.
Warning
The maintenance support must be used when
inspection and/or maintenance or repairs are to be
performed within the lifting mechanism.
Failure to use this safety mechanism could result
in death or serious injury.
Proper Use of Maintenance Support
• Remove all material from platform.
• Raise platform until there is adequate clearance
to swing down the maintenance support. Refer
to
Section 2.5-3 on how to raise the platform
using the base controls.
• Swing maintenance support down from storage
bracket into a vertical position.
• Remove hands and arms from scissor assembly
area.
• Lower platform until bottom end of maintenance
support contacts the labeled cross bar and
scissor assembly are supported by maintenance
support. Refer to
Section 2.5-4 on how to lower
the platform using the base controls.
1
To Store the Maintenance Support
• Turn on emergency main power disconnect
switch.
• Raise platform until there is adequate clearance
to swing up the maintenance support.
• Swing bar up into storage bracket.
• Lower platform.
Warning
Do not reach through the scissor assembly when
the platform is raised without the maintenance
support properly positioned.
Failure to avoid this hazard could result in death
or serious injury.
2.2-9 AC Outlet on Platform
AC Outlet on Platform - This outlet is a source of
110V/220V power on the platform.
Figure 2-7. AC Outlet on Platform