8
Back
1.7 Accessories
1.7.1 Assembling the Skycut Stand
•
If you purchased the optional stand, please refer to this
for detailed instructions on assembling the
stand and mounting the cutter onto it.
1.7.2 Test Pen
•
The test pen is used in calibrating the
Scale
(
Section 3.8
) and is also recommended for test drawing while
you are learning where shapes will cut based on various software settings. Note that a small piece of wax
needs to be removed from the pen’s nib before use. You may also wish to cut off the very top of the pen
refill so that it more easily fits into your EV24:
1.7.3 Skycut Blades
•
There are three kinds of blades that fit inside a Skycut blade holder:
Spring goes over the top of the pen insert
and stops at a small ridge on the insert
•
Pinch Wheels (4 on 24” model): grip the mat or material so that the grit
shafts beneath will feed the mat or material in and out during cutting
•
Pinch Wheel Lever: raises and lowers the pinch wheels
Pinch Roller Lever
Pinch Rollers
Platen
Right
Cover
Left
Cover
