SKS-Kinkel Elektronik GmbH
EN
300101 Table installation kit
Support-Hotline: +49 (0) 2661 98088 112
- 17 -
Version: 1.1
E-Mail: [email protected]
Document art. no. 97011101
3.1.2
Mounting
Using the screws attach the supporting frame of the indoor station to
the table installation kit. Please use the fastening holes provided on
the upper and under part on the table installation kit.
Pay particular attention to the installation cable when mounting
the supporting frame!
Connect the terminals to the previously installed cable. The terminals
are located at the back of the indoor station.
The pre-assembled cables are then connected to the indoor station.
To avoid errors when connecting cables please use the planning
guide or the wiring diagram. Pay particular attention to the
setting of the DIP switch when the indoor station is replaced!
Set the SKS bus call address at the DIP switch on the back of the
indoor station. Each address is assigned to a bell button at the door
station. The SKS bus table of call addresses can be found in the
appendix.
