SKS-Kinkel Elektronik GmbH
300022 Switching actor
EN
Support Hotline: +49 (0) 2661 98088-112
Support E-Mail: [email protected]
Version No. 2.0
Document No. 97004702
16
2.3
Scope of delivery
3
1 x Switching actor 300022
2.4
Storage and transport
Transport in original packaging only, store in a dry and cool place.
2.5
Care instructions
Just clean the device unit with a soft cloth, moistened with a mild soap solution. Dry cleaning, aggressive detergents
and abrasives may damage the surface.
2.6
Modification
A modification (alteration or conversion) of the Switching actor 300022 is not allowed.
2.7
Safety
Electrical shock hazard to persons. Danger of burns, damage to device and malfunctions.
VDE 0100 and VDE 0800 guidelines must be complied during installation. (Germany)
Counter measures:
3
Before beginning any work, deactivate and disconnect all energized electrical wires.
3
Secure the switched off/disconnected lines against erroneous reconnection.
3
Use a measuring device to make sure that the wires are de-energized.
3
Cover up any adjacent, energized or conducting components.
3
All work and all electrical connections must comply with the national provisions for the country in question and
must be performed by appropriately trained personnel.
Mounting, installation, reparation and initial setup must be carried out by qualified elec
-
tricians only! When working on systems with 230 V alternating voltage the safety require-
ments of DIN VDE 0100 must be complied with.
The SKS planning guide (can be downloaded from www.sks-kinkel.de) must be followed during installation!
3 Signalling
3.1
Power LED
The power LED, located left of terminals a+/b- shows the operation mode of the Switching actor 300022. When lit in
green the device is ready for use.
3.2
Storage LED
The storage LED is located inside the housing below rotary switch P2. It shows which storage place a call address
has been saved in and whether storing or deleting was performed successfully.
LED status
Description
LED lights up for 2 seconds at the
end of the storing process
Storing successful
LED flashes 20 x for 0.1 seconds
each at the end of the storing pro-
cess
Storing not successful, e. g. if storage space is full
