DOL 434 LPV
Technical Manual
41
When loading you can select between loading settings, loading
pages or loading settings and pages.
Note that the CAN protocol and IP setup is also saved when using the backup function.
Please note that there should only be one USB stick in the CPU module at a time when it is used
for storage of data and logs.
Save
Save settings and pages from the controller on the SD card or USB stick.
Load
Load settings and pages from the SD card or USB stick onto the controller.
Backup
Create a backup copy of the controller data. Among other things data comprises
settings, pages, historical data, house name, IP address, calibration values, etc.
Restore
Restore data on the controller from the backup. Among other things data comprises
settings, pages, historical data, house name, IP address, calibration values, etc.
Daily backup
Activate backup of the controller data every night at 01:30.
Format SD card
Format USB stick
Erases all data from the SD card or USB stick.
SD card status
USB stick status
See the status of the SD card or USB stick.
SKOV A/S recommends that you always save the setup on a USB stick before updating a program.
6.4 Software update
Important information
Loading a new program usually takes up to two minutes.
During the update, the power supply must not be interrupted and the USB stick must not
be removed before the software update has completely finished, i.e. before the graphic
user interface is accessible and usable again.
We advise against updating software when there are animals in the house.
During the update, all relays are released, e.g. to the shutter motors. The ventilation system will
thus be open, and all other functions will disconnect.
Should it be necessary to update the software while there are animals in the house, the update
should be carried out in the presence of an animal expert and observing the following precaution:
