Skov DA 1200 Wall Inlet, Mounting Manual

Page: 22 / 32

Open and close the ventilation system twice.
Adjust all the inlets to be fully open at fully open
ventilation system.
Close the ventilation system. Check that the inlets
can close (5% slack on the winch motor).
Carefully adjust the clamps with a hammer.
At manual operation the strings can be placed in
the string and pull rod holder where they can be
locked in any position.
6
Mounting Other Accessories
6.1 Extension Piece
The extension piece is applied if there are
obstacles such as heavy-duty concrete pillars or
the like up to 240/400mm and where it is not
possible to run the pull rod directly through.
Use clamp with screw included in the regulation
set.
See section 5 regarding mounting of string.
Drill two 6mm holes in the front of the inlet
casing, note the centre marks. Drill approx 28mm
deep holes.