9
SKOPE TME Series
Servicing
User Manual
Lighting
This chiller is designed for use with LED tubes and is not compatable with
fluorescent tubes.
Interior Light
Depending on the model, the chiller will have either one or two interior lights
which can be replaced without moving shelves or removing product.
Interior light specifications
To replace a chiller interior side light
To replace a chiller interior pillar light
IMPORTANT
DO NOT
use fluorescent tubes.
Model
Configuration LED Tube Specification
SKOPE Part No.
TME475
1 × side light
22W, 1500mm, T8 LED tube
ELL10180
TME650
1 × side light
22W, 1500mm, T8 LED tube
ELL10180
TME1000 2 × side lights 22W, 1500mm, T8 LED tube
ELL10180
TME1500 2 × pillar lights 24W, 1500mm, T8 twin LED tube ELL10603
1. Disconnect the chiller from the power supply.
2. Remove the diffuser by squeezing it until it is released from the housing, and
then push the diffuser out of the way.
3. Rotate the LED tube until
the pins on the ends of the
tube align with the slots,
then slide it out.
4. Fit a new LED tube.
Ensure the LED tube is
fitted with the power end
at the top (usually marked
‘POWER’ or similar).
5. Refit the diffuser by slipping the back section into the housing, then
squeezing and snapping the front section of the diffuser into place as you
work down the length of the light.
1. Disconnect the chiller from the power supply.
2. Prop the doors open and
remove the fixing screw
from the bottom of the
pillar cover.
3. Unclip and detach the
pillar cover down the
length of the pillar to
access the LED tube.
Take care not to tug or
damage wires when
detaching the cover.
Continued over page
