5
SKOPE TME Series
Installation
User Manual
Positioning the Chiller
Power Cord
The chiller has a flexible power cord fitted with a 3-pin plug, which exits
below the rear sign panel. Pull the power cord around so that it’s not trapped
before you position the chiller.
Chiller
Location
The location of the chiller may be the single most important decision that will
extend its life and ensure economical, high performance. We recommend
that you put the chiller in the coolest place possible because it will use less
power and last longer.
Allow adequate space for door/s to open and close properly. Self-closing
doors have internal torsion bars pretensioned at the factory and must be
unobstructed. Ensure the chiller sits on a level surface so that the door/s
shut and correctly seal. Level footing also prevents the condensate tray from
overflowing.
The maximim recommended ambient temperature for the chiller is 40°C.
Ventilation
For effecient operation of the chiller, it is essential that adequate ventilation
be provided above the refrigeration unit. Ensure there is always at least a
200mm gap abetween the top of the sign panels and ceiling. Never store
cardboard cartons or other objects on top of the chiller.
Stabiliser Feet
TME475 chillers are fitted with two stabiliser feet, located next to the front
castors at the cabinet base.
To provide adequate stability, both stabiliser feet
MUST
be screwed down
clockwise to contact firmly with the floor (see below). Once firm floor contact
has been achieved, rotate the locking nut anti-clockwise up to the top of the
thread to lock the stabiliser foot in place.
Ensure the stabiliser feet are raised when moving the chiller.
IMPORTANT
To ensure effecient and reliable operation, a minimum of
200mm clear ventilation space is required above the
refrigeration unit.
Stabiliser foot
Lockable front
castor
Thread
Locking nut
WARNING
The stabiliser feet on TME475 chillers
must
have firm floor
contact when the chiller is in position.
