5
SKOPE BME ActiveCore
Installation
User Manual
Positioning the Cabinet
Climate Class
The chiller is designed to operate within a climate class 5 environment (40°C
@ 40% RH). We recommend that you put the chiller in the coolest place
possible because it will use less power and last longer.
Chiller
Location
The location of the chiller may be the single most important decision that will
extend its life and ensure economical, high performance. Allow adequate
space for the door/s to open and close properly. Self-closing doors have
internal torsion bars pretensioned at the factory. Ensure the cabinet sits on
a level surface so that the door shuts and correctly seals, and that the doors
are unobstructed. Level footing also prevents the condensate tray from
overflowing.
Power Cord
The chiller has a flexible power cord fitted with a 3-pin plug, which exits the
rear of the cabinet at floor level. Locate the power cord before the cabinet is
moved into position so that it is not trapped behind the cabinet.
Ventilation
Ensure there is always at least a 50mm gap around the back, top and
underside of the cabinet. Keep the ventilation slots in the lower front panel
clear at all times.
Never
store cardboard cartons or other objects in front of
the chiller.
Before
Operating
Ensure both rear spacers are fully extended outwards and locked into place.
This will provide the necessary air gap at the rear of the cabinet for correct
operation.
CAUTION
To prevent over heating and conserve energy, ensure air flows
freely all around the chiller - including front, back, top and
underside (minimum 50mm gap).
Back of chiller
Rear spacer
