47
SKOPE BackBar X
Replacement Procedures
Service Manual
Evaporator
Fan Assembly
The evaporator fan assembly is made up of a fan motor, fan blade and a
mounting bracket which can be replaced if necessary.
If the fan stops for any reason, check all connections to ensure no plugs
have come loose. Refer to the label on the unit electrics box cover to identify
the condenser fan plug and socket on the unit electrics box.
It is important that the fan blade and/or fan motor is replaced with the same
part to ensure correct alignment and refrigeration performance. Fan blades
should be tightened to 2.1Nm.
The evaporator fan assembly can be accessed from inside the cabinet, or
by removing the refrigeration unit.
To remove the evaporator fan assembly
To replace the evaporator fan blade
1. Remove the unit front cover and isolate the chiller fom the power supply (see
2. Disconnect evaporator motor flex from unit electrics box.
3. To remove the assembly via the cabinet interior (when cabinet is unloaded):
Gain access to the assembly by removing the duct transition from inside the
cabinet.
To remove the assembly from outside the cabinet (when cabinet is loaded
with product): Remove the refrigeration unit (see page 46).
4. Undo the screws holding evaporator fan shroud in place, pull the fan shroud
out from the unit and pull the flex through the evaporator box.
1. Remove the unit front cover and isolate the chiller from the power supply
(see page 40).
2. Remove the evaporator fan assembly (see steps above).
3. Detach and replace the fan blade (take note of blade orientation when
removing).
4. Refit the evaporator assembly, reconnect to the power supply and check for
correct operation.
Evaporator fan
motor
Evaporator fan
shroud
Cabinet interior
Evaporator coil
Removal via cabinet interior pictured
