Skope ActiveCore SKT series, Service Manual

Page: 58 / 82

58
Replacement Procedures
Service Manual
SKOPE TME ActiveCore
Doors
Alignment
Adjustment
If a door is out of alignment, realign it by loosening the top hinge bracket
fixing screws, and move the top of the door as required.
Height
Adjustment
A height adjustment block is fitted below the bottom hinge. As standard, the
notched edges on the bottom of the hinge and the top of the height
adjustment block align to set the door to the correct level. If the door is not
at the correct height when at the standard setting, follow the steps below to
adjust the height.
Note: The door height cannot be adjusted on solid door cabinets, and on the
middle door on three door models.
To adjust the door height
Replacing the
Gasket
The one-piece door gasket clips into the door frame and runs around the
perimeter of the door. Remove the gasket by peeling it from the door frame,
starting at a corner.
If the gasket is out of shape after refitting, use a hair dryer to heat and
reshape it.
Removing and
Refitting the
Door
For ease of servicing and to reverse the hinging, the door can be removed
from the cabinet. Refer to image below for door hinging components.
To remove the door
WARNING
For safe door operation the door bottom hinge bracket must
always be fitted with a split pin.
1. Isolate the chiller from the power supply .
2. Loosen off the bottom
hinge, and remove the
height adjustment block.
3. Set the door to the correct height, rotate and refit the height adjustment block to
the most appropriate setting and tighten up the bottom hinge screws.
Bottom hinge
Height adjustment
block
1. Isolate the chiller from the power supply.
2. Remove the sign panel.
Continued over page