– Remove outer seal
⇒ “2.20 Removing and installing the outer window channel
– Mask off the protective foil from the bolt hole -3-.
– Unscrew screw -3-.
– Partly remove window run
⇒ “2.16 Removing and installing the window run”, page 117
– Slide the seal on the inside of the fixed door window below the
leg of the door frame so that the tools can be inserted on the
provided point.
– Insert the tool T30116 - 2 - between the pane and the door
frame towards the first unlocking bolt (in position as shown in
the illustration).
– Detach the fixed pane -1- slightly after releasing from the door
frame.
– Insert the tool T30116 - 2 - between the pane and the door
frame towards the second unlocking bolt (in position as shown
in the illustration).
– Detach the fixed pane -1- slightly after releasing from the door
frame.
– Carefully push the fixed pane out of the door frame.
Installing
– Insert the fixed pane into the door frame.
– Insert the securing bolts into the openings in the door frame
and clip in.
– Push the seal of the fixed pane over the door frame and cor‐
rectly insert the pane.
– Screw in screw - 3 - (6 Nm).
– Stick protective foil over bolt hole - 3 -.
– The further work procedure occurs in the reverse order to the
removal.
Note
The securing bolts are component parts of the fixed pane. In case
of damage, the fixed pane must be completely replaced.
2.19
Removing and installing the inner window channel strip
Rapid NH 2014 ➤ , Rapid Spaceback 2014 ➤
Body Work - Edition 10.2018
2. Door internal parts
121
