Page 9 of 56
SKIPPER
Electronics AS
Edition: 2021-09-16
ESN100 Operation and Installation Manual
Chapter: Introduction and Specification
Wiring
The transceiver unit may be positioned in any suitable dry area (IP56)between display unit and transducer.
Normally this will be near the bridge area for easy supply of 24VDC supply.
If the transducer(s) are forward then there is an alternative to position the transducer in bow area closer to
the transducer to avoid any electronic noise on the analogue signal between the transducer and transceiver.
Transducer cable type:
1 x shielded pair (twisted pair recommended if available)
