Ski-Doo Formula S 1998, Shop Manual

Page: 287 / 338

Section 08 STEERING/FRONT SUSPENSION
Subsection 02 (STEERING SYSTEM)
08-02-6
7,23,24,25, Steering Pad, Bolt, Nut and
Rubber Attachment
Properly fit the steering pad to the handlebar. As-
semble using the 2 rubber attachments, nuts and
bolts.
1. Rubber attachment
2. Nut and bolt
STEERING ADJUSTMENT (SKIS)
Definitions
TOE-OUT:
A difference in measurement between front edge
A and rear edge B of skis as viewed from top side
of suspension system. It is adjustable.
CAMBER:
A specific inward or outward tilt angle of ski leg
compared to a vertical line when viewing vehicle
from front.
This angle is not adjustable on these
models.
Adjustments
Tundra II LT
Adjustments should be performed following this
sequence:
– Pivot arm centering/horizontal handlebar.
– Set toe-out.
PIVOT ARM CENTERING/HORIZONTAL
HANDLEBAR
Turn handlebar until pivot arm is well centered in
slot of its bracket.
Check if handlebar is horizontal. To adjust, loosen
lock nuts of short tie rod and turn it accordingly.
-
CAUTION
Prior to installation, perform handlebar ad-
justment
;
WARNING
Make sure that the steering pad and all con-
trols are properly fixed to their normal loca-
tion on the handlebar.
A09G05A
1
2
A01G04A
B
A
B
A