Ski-Doo Formula S 1998, Shop Manual

Page: 153 / 338

Section 05 TRANSMISSION
Subsection 03 (DRIVE PULLEY)
05-03-4
1. Identify
2, Cap, Washer and Disk
These are calibration parts. Refer to TECHNICAL
DATA 10.
Tundra II LT
Unscrew set screw no. 4 then use spring cover
tool (P/N 529 0273 00) to unscrew spring cover
no. 5 .
Mount tool in a vise for cover hand-unscrewing.
Remove washer no. 10 then circlip no. 11 .
377 Engine S-Series
Install spring cover tool (P/N 529 0273 00) with
clutch puller (P/N 529 0314 00) on spring cover.
1. Puller tool
2. Spring cover tool
Screw puller (hand tight) to hold spring cover and
remove screws holding spring cover.
Slowly unscrew clutch puller to release spring
pressure.
Remove spring cover no. 5 , spring and washer
no. 11 .
CLEANING
All Models
Clean pulley faces and shaft with fine steel wool
and clean dry clutch. Clean sliding half bushing
with clean dry cloth.
INSPECTION
Check sliding half for excessive lateral play and
fixed half shaft for scratches. Replace as required.
ASSEMBLY
Install circlip no. 11 then washer no. 10 .
Make sure to install blocks at their original posi-
tion and with their curved end toward governor
cup. See following illustration.
Tundra II LT
Screw spring cover to 2 to 3 mm (1/16 to 1/8 in)
down below sliding half end. Apply Loctite 271 on
screw threads. Install set screw aligned with
spring cover slot.
A05D0LA
1
1
A05D0MA
529 0273 00
A03D2HA
2
1