Ski-Doo Formula S 1998, Shop Manual

Page: 137 / 338

Section 04 ENGINE
Subsection 09 (CARBURETOR AND FUEL PUMP)
04-09-8
CHOKE
Touring E/LE, Skandic 380/500 and
Formula S/S Elec./SL
Choke Plunger Adjustment
Set choke lever to fully open position.
CHOKE LEVER — FULLY OPEN POSITION
Use small diameter of tool for VM 34 carburetors.
Insert choke plunger tool into choke air inlet of
each carburetor. Tool stopper may not lean
against recess wall. Though it must be within
1 mm (.040 in) of recess wall.
AIR SILENCER SIDE SHOWN
1. Tool stopper within 1 mm (.040 in) of recess wall
CUTAWAY (ENGINE SIDE SHOWN)
1. Choke plunger
2. Tool properly seated under choke plunger
If tool tip does not seat under choke plunger
no. 15 , adjust as follows:
Make sure choke lever is at fully open position.
Lift up protector cap and loosen choke cable lock
nut, as shown in the next photo.
1. Lift up protector cap
2. Loosen lock nut
Turn choke cable adjustment nut by hand until tool
properly seats under choke plunger.
NOTE: A light pressure should be needed to posi-
tion tool under plunger.
A01C5HA
1
A01C5EA
A01C5FA
1
2
2
A01C5GA
1