Ski-Doo Formula MACH 1, Shop Manual

Page: 210 / 304

Section 06 ELECTRICAL
Subsection 06 (TESTING PROCEDURE)
06-06-5
1. 3-01 housing
5. Compare readings with those appearing in the
IGNITION table.
7. HIGH VOLTAGE COIL VOLTAGE
TESTING
1. Disconnect spark plug cap from spark plug.
2. Fasten alligator clip to spark plug cable, near
the spark plug.
3. Connect other multimeter wire to engine (ground),
then place selector switch to and scale to
0.00
VAC
.
4. Activate the manual starter and check values in-
dicated by the multimeter.
5. Repeat operation 3 times.
TYPICAL
6. Compare readings with those appearing in the
IGNITION table.
8. MPEM SUPPLY VOLTAGE
TESTING
Grand Touring 700/SE only
1. Disconnect the 10-05 and 10-01 housings be-
tween module and main harness.
2. Connect multimeter probes to RED/BLUE and
BLACK wires coming out from harness. Place
the selector switch to
and the scale to
00.0
VAC
.
3. Activate the manual starter and check values in-
dicated by the multimeter.
4. Repeat operation 3 times.
1. 10-01 housing
2. 10-05 housing
5. Compare readings with those appearing in the
IGNITION table.
9. MPEM TESTING
Grand Touring 700/SE Only
1. Disconnect the MPEM.
2. Install a known-good MPEM directly ( not to the
main harness ). Connect DESS switch, trigger
coil, high tension coils, ground (black wire of
10-01 housing), 10-05 housing to the diagnostic
housing.
A30E0QA
1
V
˜
A05E0DA
V
˜
A30E0RA
1 2