Ski-Doo Formula 500 1998, Shop Manual

Page: 279 / 398

Section 07 REAR SUSPENSION
Subsection 02 (SC-10 SUSPENSIONS (ALL VERSIONS))
07-02-9
At installation, cap opening must be 180° from
spring stopper opening.
1. Cap opening
2. Spring stopper opening
20, Stopper Strap
Inspect strap for wear or cracks, bolt and nut for
tightness. If loose, inspect hole for deformation.
Replace as required. Make sure it is attached
through proper hole from the end. Refer to TECHNI-
CAL DATA 10-03. Torque nut to 11 N•m (97 lbf•
in ).
1. 1 st hole
2. 2 nd hole
A. 11 N•m (97 lbf• in )
17, Slider Shoe
Measure slider shoes from the bottom to the 0.5
mm (.020 in) radius as shown on the next photo.
Minimum thickness must be 2 mm (.080 in).
TYPICAL
1. Slider shoe
2. Molding line (this line is not the wear limit)
A. Wear limit measurement (must be at least 2 mm (.080 in))
Replace slider shoes when wear limit is reached.
18, Spring Support
RIGHT SIDE SHOWN
1. Right position: upward
2. Wrong position
A03F12A
1
2
A03F0QA
A
1
2
-
CAUTION
Slider shoes must always be replaced in
pairs.
-
CAUTION
To avoid track damage, spring supports
must be mounted upward.
A01F2MA
1
2
A
A03F0VA
1
2