Ski-Doo Formula 500 1998, Shop Manual

Page: 179 / 398

Section 05 TRANSMISSION
Subsection 03 (DRIVE PULLEY)
05-03-6
1,2,3, Screw, Ring Gear and Loctite 271
Apply Loctite 271 (P/N 413 7029 00) on threads
and then torque to 27 N•m (20 lbf•ft).
26,27,28, Calibration Screw, Washer
and Locking Nut
When installing calibration screw, make sure to in-
stall washer as shown.
1. Washer
Torque locking nut to 10 N•m (89 lbf• in ).
15, Pin
Always use the same type of pin as originally in-
stalled when servicing. Different types have dif-
ferent weights for calibration purpose. Refer to
TECHNICAL DATA 10-03.
21,22,23, Ramp, Dowel Tube and Screw
Insert dowel tube from chamfered side. Make
sure ramp is centered on dowel tube.
1. Chamfered side
Position dowel tube split at the illustrated angle.
1. Equal distance
Torque screws to 10 N•m (89 lbf• in ).
9,11,13,14, Screw, Lever Ass’y, Nut and
Cotter Pin
Always install lever assemblies so that cotter pins
are on the shown side. Besides install cotter pin
head on top when lever is sat at bottom of sliding
half. Bend cotter pin ends to sit perfectly against
lever.
A16D07A
1
A16D08A
1
◆
WARNING
Whenever replacing centrifugal levers, al-
ways replace all 3 at the same time. Other-
wise, clutch misbalancing will occur be-
cause of levers difference.
A16D2PA
30
±
5
°
A16D09A
1 1