DRIVE SYSTEM
Belt Guard Removal and
Installation
WARNING
NEVER operate engine:
– without shields and belt guard
securely installed
– with hood opened or removed.
NEVER attempt to make adjust-
ments to moving parts while en-
gine is running.
NOTE:
Belt guard is purposely made
slightly oversize to maintain tension on
its pins and retainers preventing un-
due noise and vibration. It is important
that this tension be maintained when
reinstalling.
– Remove tether cord cap.
– Open engine compartment.
– Open retainer to release pin then
pull belt guard out of vehicle.
mmo2006-004-015_a
TYPICAL
1. Pin retainer
When reinstalling belt guard, position
its cutaway toward front of snowmo-
bile. Refer to decal in belt guard.
Place belt guard slots over tabs first,
then snap the other end in retainer.
mmo2006-004-016_a
TYPICAL
1. Slots
Brake Fluid Level
CAUTION:
Vehicle must be on a lev-
el surface before checking any fluid
levels.
Check brake fluid (DOT 4) in reservoir
for proper level. Add fluid (DOT 4) as
required.
CAUTION:
Use only DOT 4 brake
fluid from a sealed container. Nev-
er use any other types of fluid.
mmo2006-004-017_a
1. Brake fluid reservoir
76
______________________
Summary of Contents for 2006 RF series
