CAUTION:
The snowmobile has to be stored in a cool and dry
place and covered with an opaque tarpaulin. This will prevent
sun rays and grime from affecting plastic components and vehi-
cle finish.
Lift rear of vehicle until track is clear of the ground. Install on a wide-
base snowmobile mechanical stand with a rear deflector panel.
WARNING
Do not attempt to lift the vehicle by hand alone. Use appro-
priate lifting device or have assistance to share lifting stress in
order to avoid risk of strain injuries.
NOTE:
Do not release track tension.
Belt Guard Removal and Installation
WARNING
NEVER operate engine:
– without shields and belt guard securely installed
– with hood opened or removed.
NEVER attempt to make adjustments to moving parts while
engine is running.
NOTE:
Belt guard is purposely made slightly oversize to maintain ten-
sion on its pins and retainers preventing undue noise and vibration.
It is important that this tension be maintained when reinstalling.
– Remove tether cord cap. Open engine compartment.
– Open retainer to release pin then pull belt guard out of vehicle.
_________________________
131
Summary of Contents for 2005 Rt series
