Protection
IMx-M Manager
SKF Multilog On-Line System IMx-M
2 - 81
User Manual
Clear Display Window
clears the output window.
Capture to Disk
saves responses or messages generated by commands
and interfaces to a file. It will be located in the same directory as the currently
open project.
Advanced debug mode
shall not be used. This is only for a critical fault
recovery situation where SKF Condition Monitoring Center must be contacted
first.
Validating and Saving Protection Configurations
Validating and Saving are done on the Project level which include configurations of all
the installed slots.
Figure 2 - 55.
"File" Menu.
To validate slot configurations, from the Main Menu, select
File
and
Validate
.
Assuming there are no issues, return to the main menu, select
File
and then
Save
. This
will either create a new, or update an existing master project file (*.mhf) and slot
configuration files (*.bin).
Detailed information is to be found in
chapter.
Sending Protection Configuration to Protection Module
Once the slot configuration has been validated and the configuration file (*.bin) has been
created and saved, this slot configuration file can be sent to a protection module.
Disarming a Slot
Before the slot configuration file can be sent, the slot must be disarmed. See
for different ways to disarm slot.
Sending Protection Configuration to PRM
The procedure of sending the protection configuration (.bin) to protection module is
described in the
