Installation Instructions
Pump P 215
810-55192-1
Page 31 / 45
Rev. 012
2018/11/30
8.6. Inadvertent filling with incorrect lubricant
Should incorrect lubricant have been filled, please proceed as follows.
➢
Switch off the pump and secure it against being switched on.
➢
Remove lubricant.
➢
Clean the reservoir, pump housing and, if applicable, the tubing system.
➢
Fill in lubricant of correct specification.
➢
Switch on pump.
➢
Inform your superior to ensure that the error does not occur again.
8.7. Inspections prior to initial commissioning
In order to warrant safety and function, a person assigned by the operator must
inspect certain areas of the central lubrication system prior to initial commissioning.
Detected defects must be reported without delay to a superior and remedied. The
repair of defects must be carried out by a specialist only.
The following points must be inspected prior to initial commissioning:
ATTENTION
Risk of damage to the machine
Fill the feed lines with lubricant and lubricate the lubrication points manually.
Otherwise the bearing points may become damaged due to a lack of lubricant.
Check the entire system for accordance with the intended purpose and the
planning documentation.
Ensure that all parameters and lubricants have been correctly adjusted or are
present.
If deviations are detected, they must be remedied without delay.
Summary of Contents for Lincoln 215-M049
Page 1: ...Installation Instructions Pump P 215 810 55192 1 Page 1 45 Rev 012 2018 11 30 P 215...
Page 23: ...Installation Instructions Pump P 215 810 55192 1 Page 23 45 Rev 012 2018 11 30...
Page 43: ...Installation Instructions Pump P 215 810 55192 1 Page 43 45 Rev 012 2018 11 30 M100 M049 100XY...
