- 16 -
951-180-087-EN
Version 01
EN
1. Safety instructions
○
All
components used must be designed
for:
- The maximum operating pressure
- The maximum/minimum ambient tem-
perature
- The lubricant to be delivered
- The required ATEX zone
- The operating and ambient conditions
at the place of use.
○
No parts may be subjected to torsion,
shear, or bending.
○
Check parts for contamination before use
and clean if necessary.
○
Lubrication lines should be filled with lu-
bricant prior to assembly. This simplifies
subsequent venting of the system.
○
Adhere to the specified torques. Use
a calibrated torque wrench when
tightening.
○
Avoid mixing up/incorrectly assembling
disassembled parts. Label parts.
1.18 First start-up, daily start-up
Ensure that:
○
All safety mechanisms are fully present
and functional.
○
All connections are properly connected.
○
All parts are correctly installed.
○
All warning labels on the product are fully
present, visible, and undamaged.
○
Illegible or missing warning labels are
immediately replaced.
