- 10 -
951-180-087-EN
Version 01
EN
1. Safety instructions
1.3 Intended use
P
ulse generator
24-2583-2526
of the
series SP/SFE 3003 and
24-2583-2528
of
the series SP/SFE 3006 are used to
monitor volumetric oil and grease flows
from 0,1 to 50 cm
3
/min at a maximum per-
missible operating pressure of 600 bar (24-
2583-2526) or 350 bar (24-2583-2528).
The pulse generator 24-2583-2526 with
built-in dry contact is classified as simple
electrical equipment according to the re-
quirements of the standard EN 60079-11,
paragraph 5.7 and may only be used in in-
trinsically safe circuits.
The data and values listed in the “Technical
data” chapter must be observed.
Any other usage is deemed non-compliant
with the intended use.
1.4 Foreseeable misuse
Any usage of the product other than as
specified in this manual is strictly prohibited.
Particularly prohibited are:
○
Use outside the specified operating tem-
perature range
○
Use of non-specified equipment
○
Use in areas with aggressive, corrosive
substances (e.g., high ozone loads)
○
Use in areas with damaging radiation
(e.g., ionizing radiation)
○
Use to feed, forward, or store hazardous
substances and mixtures as defined in
Annex I Part 2-5 of the CLP Regulation
(EC 1272/2008) that are marked with
hazard pictograms
GHS01-GHS 09
○
Use to feed / forward / store gases,
liquefied gases, dissolved gases, va-
for proper function and completeness at
regular intervals.
○
If protective and safety mechanisms
must be removed, they must be rein-
stalled immediately following conclusion
of work and then inspected for proper
function.
○
Any malfunctions that occur must be
resolved according to responsibility. The
supervisor must be notified immediately
in case of malfunctions outside one's in-
dividual scope of responsibility.
