VD32 Remote Controller User Manual v1.2
- 87 -
2020 SIYI Technology Copyright
2.
Please link the transmitter 1 to the sky station first, then turn on “Remote Control
Relay” in the “General Settings Relay” menu; the transmitter 1 is the slave
transmitter;
3.
Then link the transmitter 2 to the sky station; the transmitter is always the master
transmitter even if you restart the sky station or transmitter.
7.2 Voltage Calibrating
Before using the sky station, it is necessary to calibrate the telemetry voltage of
both the sky station and the aircraft.
Here are some preparing work before calibration:
1.
Power on the sky station and the transmitter;
2.
Link the sky station to the transmitter.
Steps to Calibrate the Telemetry Voltage of the Sky Station (RX)
1.
Power on the sky station through any of the PWM port, the voltage range is from
3.6V to 10V, measuring by a multi-meter;
2.
Let’s take an example of 6.0V; select “Standard Voltage” in the RX menu, tap on
