Use and Maintenance Manual
–
002.108A of _27/09/2021
Square Baler
–
M 60 Mini/S
–
M 60 Mini
–
M 60 Super
24
ENGLIS
H
5.1 Checks before putting into operation
Before putting the baler into operation, carry out the following steps:
Check all the lubrication and greasing points (see “Lubrication and Maintenance” chap. 6).
Check to
make sure the nuts and bolts have not loosened, and tighten them if necessary.
WARNING!
Before putting the machine into operation, see Table 6.1.
Check that there is twine and the correct tensioning (see chapter 5.5).
Check that all shear bolts are in good condition.
Check to ensure that the control mechanisms move freely.
Clean the chamber guides from any residue buildup.
DANGER!
All protective guards must always be closed before starting the machine, and must be reopened only
after stopping the machine, engaging the parking brake, turning off the tractor engine and removing
the ignition key.
When starting, the hydraulic jacks are empty, and when first activated they can cause sudden
movements or parts of the machine to fall. Operate them several times using great caution and
keeping people away from the machine.
All movements with the tractor must be made checking to make sure there are no persons or objects
in its path.
Failure to do so can result in death or serious injury.
5.2 Hitching to the tractor
The baler is hitched to the fixed bar of the tractor and is driven by the PTO. Position the machine
horizontally using and regulating the parking stand so that the bale chamber is parallel to the ground.
Hitch the machine to the tractor in reverse, positioning the towing eye at the desired height (adjusting
the height position of the tractor if necessary) and making sure it is securely fastened.
Next, raise the machine parking stand, placing it in the position shown in Fig. 5.2.
