Do not use
any hand drill
on this product
PHILLIPS SCREWDRIVER
( not included )
1- After laying out all components, position the Seat ( B ) upside-down and align the Back Leg Assembly ( C ) with
the Seat Supports, as shown below. Insert a Screw ( A ) through a Seat Support into a predrilled hole and begin to
tighten the screw with a screwdriver. Once the screw is a few turns tightened, move on to another screw until all 4
have been started. With the Seat loosely attached to the Front Leg, use an additional Screw ( A ) to attach the Leg
Support to the Seat. With this 5th screw tight, finish tightening the first 4 screws into the Legs.
Figure 1
Hardware and Parts
(16)
A
1.50
D
( Front Leg
Assembly )
B
( Seat )
C
( Back Leg
Assembly )
E
( Stretcher )
Seat
Support
Leg
Support
(2)
A1
2.50
A1
A
( Back Leg Assembly )
C
Item No: MHUD-S17B
Hudson 17" Bar Height Stool
Assembly Instructions
