Overview
Siselectron SNM2410, the revolutionary DIN Rail type Industrial Gigabit managed
Power over Ethernet Switch is designed with 8 10/100TX PoE injector ports and 2
Gigabit RJ-45 / SFP combo ports for highly critical PoE applications such as real time
IP video surveillance, WiMAX systems and Wireles Aps. All of the 8 ports of the
switch are compliant with both IEEE 802.3af PoE and IEEE 802.3at high power
standards and can deliver up to 15.4W and 30W power per port to enable the
high-power requiring devices, such as Wireless Aps, PTZ and dome network cameras,
etc.
Packing List Checking
Siselectron SNM2410
DIN Rail installation clip (tightened on the rear panel)
DB-9 to RJ-45 console cable
Hardware Installation
1.
Powering of the system
The Power input port is located at the bottom side and provides 2 power input ports.
The power input port supports polarity reverse protection; the Switch won’t start if
the wrong polarity is applied. For the wiring architecture, please refer to the below
figure.
Wiring the Power inputs & Earth Grounding
1.1
Insert the positive and negative wires into the V+ and V- contact on the terminal
block connector.
1.2
Connect the Chassis Grounding to Earth Ground system to obtain
electromagnetic immunity to resist lighting, electro static discharge and electric
fast transient.
1.3
Tighten the wire-clamp screws to prevent the power wires from being loosened.
Note: User the UL Listed LPS Power supply with output rating 46-57 VDC, minimum
3.5A currents.
We recommend sing DC 48V as the operating voltage.
2.
Wiring the Relay Output (DO)
The Relay Output (DO) contacts are in the bottom side as shown in the figure on the
right. The relay output (DO) is controlled by the pre-defined operating rules.
Note: The relay contact only supports 0.5A current, DC 24V. it is not recommended to
apply voltage and current higher than the specifications.
