
.. or assign IP address without DHCP
XCU Fusion
316L stainless-steel dual imager camera
Quick Start Guide
© Siqura B.V. 2018
Version 0.4 (181904-04)
XCU Fusion QSG (MW10)
Assign IP address with DHCP…
Unpack
Mount
Install Device Manager
Connect and point
Note 1: Subject to modification. Actual product and accessories may differ in appearance.
Find additional manuals, the datasheet,
the EU Declaration of Conformity, and the latest
firmware for this product at:
siqura.com/downloads/software
siqura.com
•
1x Camera unit
•
1x Quick Start Guide
CAUTION: MAKE SURE THAT THE POWER SUPPLY VOLTAGE MATCHES THE
VOLTAGE RATING OF THE XCU FUSION. CHECK THE PRODUCT LABEL TO
DETERMINE THE VOLTAGE REQUIRED FOR PROPER OPERATION.
DO NOT CONNECT A 24 VAC MODEL TO A 115 VAC OR 230 VAC POWER SUPPLY!
10.x.y.0
Cat 5
Video Management System
NTP
Wall mounted XCU Fusion
XCU Fusion ceiling mounted on XCUCM01
XCU Fusion ceiling mounted on XCUCM02
XCU Fusion wall/pole mounted on XCUCM02
Connect to network
Connect to power (see warning below)
Pinning power connector
Note 2: For detailed mounting instructions, download the installation manual.
Note 3: The silica gel packet inside the camera must be replaced if the camera has been
opened.
Note 4: On the Siqura website, choose SDM2 2.4.0 installer or higher.