Sinterit SANDBLASTER SLS User Manual | 15
7.1.1 Exchange of Abrasive material with Sinterit ATEX Vacuum Cleaner
To remove the used Abrasive material from the chamber we recommend using Sinterit ATEX Vacuum Cleaner.
Image 9. Remowing used Abrasive material with ATEX Vacuum Cleaner.
1. Disconnect the sandblaster from the power supply
12
and the compressor
14
.
2. Gently lift the sandblaster grid
24
and insert the rubber nozzle of the vacuum cleaner into the chamber.
3. Turn on the vacuum cleaner and remove all used Abrasive material, also clean the remaining parts in the chamber
(Air filter, pneumatic tubes, housing, Protective rubber gloves).
4. Gently transfer the whole contents of the vacuum cleaner into the sealed container. Treat it as industrial waste.
5. Pour new Abrasive material into the hole in the corner of the Chamber grid
24
.
6. Connect the Power supply, compressor and vacuum cleaner.
7.1.2 Standard exchange of Abrasive Material
WARNING!
A second person is required to help with the standard Abrasive material change.
The Sinterit
SANDBLASTER SLS with the Abrasive weighs approx. 40 kg – improper maintenance (without
the help of a second person) may cause injury.
CAUTION!
•
The Inner chamber grid
24
is heavy!
•
Danger of crushing upper limbs when rising the Inner chamber grid.
