AUXILIARY OUTPUT
CONNECTION OF THE FLOOR SENSOR
(OPTIONAL)
CONNECT YOUR THERMOSTAT TO THE GT130 GATEWAY OR A COMPATIBLE ZIGBEE SYSTEM
INSTALL YOUR THERMOSTAT
Unlock and lift the
thermostat cover.
Depending on the heating system,
insert each wire into its terminal
and screw firmly. (See connection
layouts outlined in the following
pages.)
Use the provided screws and
wall anchors to fix the
thermostat's base on the wall.
Replace and lock the
thermostat cover.
1
2
4
5
Power up the thermostat.
6
If necessary, mark and drill the
appropriate fastening holes using the
installation template. If needed, use
the wall anchors included.
3
TH1400ZB
Installation Guide
Smart Low Voltage Thermostat (24 Vca)
WIRING LAYOUT
The thermostat provides an auxiliary heating output that
can act as a second stage of heating when controlling
ambient temperature.
If the room temperature is too far from the setpoint or the
main stage of heating has difficulties raising the tempera-
ture, the auxiliary output activates the secondary heating
source to reach the set temperature.
Both outputs can control different types of heating loads
and can be configured in the user settings.
C
W1
R
W2
S1
S2
120 V
240 V
347 V
24 V
24 Vac
normally open
Valve
Floor sensor
Electric floor heating
Electric baseboard
Electric baseboard
Floor sensor
For use in floor or ambient
mode with floor limit.
Not required for ambient
mode alone.
Electric floor heating with electric
baseboard on the 2nd heating stage
Hot water valve
Electric baseboard
Only for control applications in floor (F) mode or with floor limit.
Sensor
ADD YOUR THERMOSTAT TO THE GT130
GATEWAY AND NEVIWEB
Tap the then select "Add Device"
2
1
If you do not have an account yet,
download the Neviweb app for iOS or
Android to create an account and add
your device.
Follow the steps of the Installation Wizard
3
1
2
Connect all your
thermostats the same way,
by going to the next
closest thermostat.
3
4
Hub
2nd
1st
3rd
Initiate the connectivity session
by pressing the RF signal button
on the GT130 gateway. The
indicator light will start flashing.
Compatible Zigbee gateway:
refer to the installation guide for
the latter.
Connect your thermostat to the network
by pressing briefly and simultaneously
on the and buttons.
On the thermostat display:
Blinks:
Connecting
Remains lit:
Connected
If the connectivity fails, the
symbol will disappear from the
display. Refer to our Website to
troubleshoot the unit.
When all your devices are connected, close the
connectivity session of your GT130 gateway or
your compatible Zigbee gateway.
Alimentez le thermostat.