Download the free Neviweb app on your
device from the AppStore or Google Play*.
Connect the valve to an
electrical outlet, using
the supplied adapter,
near where it will be
installed. By doing so,
you will validate the
range of the Wi-Fi
communication
between the valve
and your network.
Open the app and log into your
Neviweb account or create an
account.
Follow the steps to add a
device.
1
2
4
Connect your Sinopé
smart water leak
detectors (Step 2).
5
Remove the valve
cover by unscrewing
the 4 screws with a flat
screwdriver.
3
The mode switch of the
valve must be in
position "1".
The valve must be
plugged into a
power outlet.
Connect the detector
to the network from its
installation location.
This will ensure it is
within range of the RF
signal of the valve.
Remove the cover and
insert the batteries.
Once all the detectors
are connected, press
the "B" button on the
valve to close the
connectivity session.
1
2
4
5
Press the "B" button to
open the network
connectivity session for
the detectors.
The indicator lights will
light up in sequence to
indicate that the session
is active.
3
VA4220WF
VA4221WF
Installation Guide
Smart Water Valve
Wi-Fi
*It is also possible to operate the valve without an Internet connection.
However, you will not be notified when a water leak is detected.
Refer to the "Support" section of our Website at www.sinopetech.com.
*
The connection can be verified at
any time by pressing the water leak
detector's button. The indicator light
will light up in green for 10 seconds
if the unit is connected.
WARNINGS
AVAILABLE ACCESSORIES
The installation of this valve should be performed by a certified
professional in conformity with local and national construction codes.
The valve closes with sufficient force to cut a finger. ALWAYS keep
your fingers away from the ball valve.
Although each unit is pre-tested at the factory, it is strongly
recommended that you test the valve before installation to
ensure proper operation in your home.
STEP 1
CONNECTING THE VALVE TO YOUR WI-FI NETWORK
STEP 2
CONNECTING THE WATER LEAK DETECTORS TO THE SMART WATER VALVE
*Refer to the "Support" section of our Website at www.sinopetech.com.
Press the detector's connection button.
Green light blinks
Green light lit for 10 s
Red light turns on
Device is connecting
Successful connection
Connection has failed*
Status
Light
3
2
1
Flow Sensor
FS4220
On-Off switch
SW2500ZB
Load Controller
RM3250ZB
Smart Plug
SP2600ZB
Smart Outlet
SP2610ZB
Multicontroller
MC3100ZB
