Sinoboom AB14EJ, Operation Manual

Page: 54 / 94

© Aug 2020 7-6 GTZZ14EJ&16EJ Operation Manual
OPERATING THE MACHINE
FALL HAZARD
The platform level switch can
only be used for slight leveling of
the plaform, improper use may
cause the load/occupant to shift
or fall.
6. Move the enable switch and meanwhile move
upwards/downwards the platform rotate switch to
rotate the platform clockwise or anticlockwise.
7. Move the enable switch and meanwhile move
upwards/downwards the jib up/down switch to raise
or lower the jib boom.
To drive ：
The drive function is not enabled on the ground
controller.
To steer ：
The steer function is not enabled on the ground
controller.
OPERATION FROM
PLATFORM
UNSAFE OPERATION HAZARD
• Unless in emergency situations,
do not operate from the ground
controller when there are
personnel in the platform.
• Do not operate the machine if any
control handle or switch is not
returnted to off position after
being released.
COLLISION HAZARD
When operating the boom, be sure
the area around or under the platform
is free of persons or obstacles.
Before operation ：
1. Be sure the battery is well connected before
operating the machine.
2. Turn the Ground/Platform select switch on the
ground controller to Ground.
3. Pull out the red emergency stop button on the
ground controller to the ON position.
To position platform ：
1. Depress the footswitch and meanwhile move
forward/backward the main boom lift/turntable
rotate control handle to raise or lower the main
boom.
2. Depress the footswitch and meanwhile move
leftwards/rightwards the main boom telesocpe
switch to extend or retract the main boom.
3. Depress the footswitch and meanwhile move
upwards/downwards the foldable boom up/down
switch to raise or lower the foldable boom.
4. Depress the footswitch and meanwhile move
leftwards/rightwards the main boom lift/turntable
rotate control handle to rotate the turntable
clockwise or anticlockwise.
5. Depress the footswitch and meanwhile move
upwards/downwards the platform level switch to
level up/down the platform.
FALL HAZARD
The platform level switch can
only be used for slight leveling of
the plaform, improper use may
cause the load/occupant to shift
or fall.
6. Depress the footswitch and meanwhile move
leftwards/rightwards the platform rotate switch to
rotate the platform clockwise or anticlockwise.
7. Depress the footswitch and meanwhile move
upwards/downwards the jib up/down switch to raise
or lower the jib boom.
To drive ：
1. Depress the footswitch and meanwhile move
forward/backward the steer/drive control handle to
drive the machine forward or backward.
2. Speed increase: slowly move the handle off center.
3. Speed decrease ： slowly move the handle toward
center.
4. Stop ： return the handle to center or release the
footswitch.
When the boom is in operating position, the drive speed
of the machine will be restricted.
The battery condition will affect the machine
performance. When the platform screen indicates a low
battery level, the machine drive speed and lift speed
will be reduced.