Sinoboom AB14EJ, Operation Manual

Page: 37 / 94

GTZZ14EJ&16EJ Operation Manual 6-1 © Aug 2020
6
PRE-OPERATION FUNCTION TEST
UNSAFE OPERATION HAZARD
Be sure to follow the instructions and
safety rules in this manual. Failure to
follow the instructions and safety
rules in this manual may result in
death or serious injury.
Do not operate this machine unless
you have learned and practiced the
rules for safely operating the
machine as stated in this manual.
• Know and understand the safety
rules before continuing the next
step.
• Avoid dangerous situations.
• Always check the machine before
operating.
• Select appropriate machinery and
personal protective equipment (-
hard hats, safety belt and gloves,
etc.) for the task.
• Always perform a pre-operation
inspection.
• Always perform a pre-operation
function test before using the
machine.
• Check the work site.
• Check the safety decals/
nameplate on the machine.
• Only use the machine according
to the instructions in this manual
and for its intended purpose.
Conducting a pre-operation function test helps you
discover potential problems before you start using the
machine. The operator must test all machine functions
according to the instructions in this manual.
Do not use a machine with problems or malfunctions.
Mark the machine and do not use it if you discover any
problems. Only qualified maintenance technicians can
repair the machine according to the manufacturer’s
regulations.
After any maintenance, the operator must perform
another pre-operation inspection before conducting a
pre-operation function test.
PREPARING FOR A PRE-
OPERATION FUNCTION
TEST
UNSAFE OPERATION HAZARD
• Slowly operate the control handle
with a consistent force, do not
pull hard the handle to skip the
neutral position and directly to the
reverse direction.
• When two persons are present on
the platform, all machine
operations are performed only by
the operator.
• When the machine is driving,
always keep the base boom and
foldable boom located over the
rear drive wheels. If the base
boom and foldable boom are
located over the front steer
wheels, the actual steering and
driving directions will be opposite
to the arrow directions as
indicated on the operation panel.
NOTICE
All the pre-operation function tests must be
completed within the same period.
Before beginning a pre-operation function test:
1. Select a test area that has a solid, flat, level
surface.
2. Ensure the test area is free of obstacles.
3. Storage battery is connected.